WIND SENSORS
A5120E
NMEA183 Race Wind Sensor
A5120N
NMEA183 Cruising Wind Sensor
A5120P
NMEA183 Power Wind Sensor
A5120 NMEA-0183 Series (can be used with 2K systems with converter below)
A5130E
NMEA2000 Race Wind Sensor
A5130N
NMEA2000 Cruising Wind Sensor
A5130P
NMEA2000 Power Wind Sensor
A5130 for NMEA-2000 systems
Wind direction and speed data
NMEA0183 & NMEA2000 versions available
3 arm lengths available
Direct replacement for existing wind sensor
Unique Autonnic styling
DIY installation
The Autonnic Masthead Wind Sensor provides reliable and accurate information about the speed and direction of the wind working against a yacht. The unit is built to last using robust, quality materials and is able to withstand the harshest marine environments.
​
The Autonnic Wind Sensor is directly compatible with discontinued Garmin GWS 10 wind.
​
Available in 3 sizes:
N Normal for sailing cruising
E Extended for racing
P A shorter version for Power boats
A5901/2
NMEA0183 extender cables
These cables simply allows a NMEA0183 wind head sensor to be connected to in the in-board monitoring system via the mast on a sailing boat. They are available in two lengths:
A5901 7.5m / A5902 20m
A5138
NMEA 2000 20m
extender cable
The A5138 simply allows a NMEA 2000 system to be extended. Suitable for wind sensor, heading sensor or backbone it includes a junction box so the cable can be threaded through a mast or deck gland.
A5129
WIND spares kit
Boat wind sensors are the piece of electronic equipment most likely to get damaged as it sticks out beyond the end of the mast; either in storage or during stepping or unstepping your sensor is likely at sometime to need this kit. The A5129 is a set of spare cups and accessories to repair an Autonnic wind sensor if it were to get damaged.
A5905
NMEA0183 to 2000 Converter
The A5905 allows a NMEA0183 wind head sensor to be connected to a NMEA2000 system without requiring new mast wiring. Provides power to the 0183 Masthead Sensor from the 2000 bus.
Takes in 0183 Wind data
​
Delivers NMEA-2000 Wind data
​
Can use existing masthead cable
​
Zero set-up button